vaiyo

If they are aligned, tighten the pulley and give it a shot. I would check the timing before i would check the plugs just because its a little easier. If ur car is off timing, in general, ur check engine light be on and it would idle rough. My suggestion is to eliminate the exhaust being plugged, disconnect the exhaust manifold at the point that it bolts to the down pipe. Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around. Then take it on a test drive and see if it makes a difference.

  • I had the same problem and smelled gas after hard acceleration.
  • Also, with the cam pulley that wobbles, check to make sure the timing marks on both cam pulleys and the crank pulley are aligned with the timing belt.
  • If the marks are not aligned, align them and then tighten down the pulley and give it a shot.
  • If these marks are off, it can cause BIG problems along with not starting.
  • If they are aligned, tighten the pulley and give it a shot.
  • If ur car is off timing, in general, ur check engine light be on and it would idle rough.
  • Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.

No crank, no start, no power

  • If always peps any of our cars up and the run it almost to empty, I guarantee you’ll notice a difference.
  • Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.
  • Then take it on a test drive and see if it makes a difference.
  • Try putting 2 or 3 bottles of “Lucas Fuel Injector Cleaner” in there.
  • If you dont really have experience working on cars, imo i would have someone else switch cam pulleys and put everything back to TDC.
  • If the mechanic looked at it and said your timing was off, why wouldnt you just have them do it??
  • My suggestion is to eliminate the exhaust being plugged, disconnect the exhaust manifold at the point that it bolts to the down pipe.

If the mechanic looked at it and said your timing was off, why wouldnt you just have them do it?? If you dont really have experience working on cars, imo i would have someone else switch cam pulleys and put everything back to TDC. I had the same problem and smelled gas after hard acceleration. Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up. Try putting 2 or 3 bottles of “Lucas Fuel Injector Cleaner” in there.

vaiyo

CarGurus Experts

  • If the marks are not aligned, align them and then tighten down the pulley and give it a shot.
  • I had the same problem and smelled gas after hard acceleration.
  • It’s some strong stuff bro but even Mama and Brooke can tell when I put it in there cars.
  • Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.
  • Then take it on a test drive and see if it makes a difference.
  • If these marks are off, it can cause BIG problems along with not starting.
  • Have you looked at the spark plugs to see if they need to be changed?
  • Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.

Have you looked at the spark plugs to see if they need to be changed? Also, with the cam pulley that wobbles, check to make sure the timing marks on both cam pulleys and the crank pulley are aligned vaiyo with the timing belt. If these marks are off, it can cause BIG problems along with not starting. If the marks are not aligned, align them and then tighten down the pulley and give it a shot.

CarGurus Experts

If always peps any of our cars up and the run it almost to empty, I guarantee you’ll notice a difference. It’s some strong stuff bro but even Mama and Brooke can tell when I put it in there cars.

No crank, no start, no power

No crank, no start, no power

vaiyo

CarGurus Experts

No crank, no start, no power

  • Have you looked at the spark plugs to see if they need to be changed?
  • I had the same problem and smelled gas after hard acceleration.
  • If the marks are not aligned, align them and then tighten down the pulley and give it a shot.
  • Had poor fuel economy accompanying all this with an idle of about 1000rpm sometimes 1100 after warm up.
  • Then take it on a test drive and see if it makes a difference.
  • If these marks are off, it can cause BIG problems along with not starting.
  • Try putting 2 or 3 bottles of “Lucas Fuel Injector Cleaner” in there.

CarGurus Experts

CarGurus Experts

No crank, no start, no power

No crank, no start, no power

  • I had the same problem and smelled gas after hard acceleration.
  • If you dont really have experience working on cars, imo i would have someone else switch cam pulleys and put everything back to TDC.
  • Either lossen it up enough where u can see a good size gap or completly unmount it but make sure that down pipe is not going to be swinging around.
  • If these marks are off, it can cause BIG problems along with not starting.
  • Also, with the cam pulley that wobbles, check to make sure the timing marks on both cam pulleys and the crank pulley are aligned with the timing belt.
  • It’s some strong stuff bro but even Mama and Brooke can tell when I put it in there cars.
  • If they are aligned, tighten the pulley and give it a shot.
  • I would check the timing before i would check the plugs just because its a little easier.

CarGurus Experts

No crank, no start, no power

No crank, no start, no power

Leave a Reply

Your email address will not be published. Required fields are marked *